Make another sketch on the YZ plane and then hit ctrl v to paste the sketch then hit finish sketch. You need to make a duplicate of this sketch to do this you right click on the sketch and hit copy. I made a line 11.082 inches long and then at the end I made another line going straight up. Then for me I added 5.541 to 5.541 which is 11.082 for my second part. At the end of that line make a line going straight up and make it as long as the diameter of your drumstick. Make your first line starting at the center and going the way your drumstick points, left for me, make this line as long as you want to cut it, 5.541 inches for me. Covers modeling, gear creation, linkage analysis, assemblies, simulations and 3D animation. First rotate your drumstick so its horizontal, use the arrows next to the cube, than start a new sketch on the YZ plane (Same as in step 10). Teaches beginners how to use Autodesk Inventor with easy to understand tutorials. The total length of my drumstick is 16.625 so I divided that by 3 which was 5.541. First you need to decide where your going to cut it, I will be doing my in thirds. If your printer is big enough to print your drumstick whole you can just skip this part but if your printer is like mine your going to have to cut it up and glue it. To be sure that you made it, trace the rectangle again with the line tool. You should have 4 yellow dots in each corner of the rectangle, like the picture above. Using the line tool, construct the rectangle. Now we need to make a rectangle between those two lines, it needs to be as thick as the drumstick. Developed by Autodesk, Inventor comes in different packages depending on level of proficiency (student, professional etc.). You should have something close to the fourth picture. Then click the dimensions tool and make it as long as the second number you calculated, for me that would be 16. Make another line starting from the middle, make this line going straight up too but make it a longer than the first line. You now should have one line, now we need to make a second line. Using the dimensions tool make that line that you just made the first number you calculated, for me that would be 13.3, then hit the green check mark. Make sure the line is going perfectly straight up. Click on the line tool in the top toolbar, make a line starting at the middle of the coordinate plane and ending going straight up, length doesn't matter because we will be using the dimensions tool.
0 Comments
Leave a Reply. |